Dodge Charger: STEERING WHEEL / Manual Tilt/Telescoping Steering Column — If Equipped

Dodge Charger 2011-2025 Owner's Manual / GETTING TO KNOW YOUR VEHICLE / STEERING WHEEL / Manual Tilt/Telescoping Steering Column — If Equipped

This feature allows you to tilt the steering column upward or downward. It also allows you to lengthen or shorten the steering column. The tilt/telescoping control is located below the steering wheel at the end of the steering column.

Dodge Charger. Manual Tilt/Telescoping Steering Column — If Equipped

To unlock the steering column, push the control downward (toward the floor). To tilt the steering column, move the steering wheel upward or downward as desired. To lengthen or shorten the steering column, pull the steering wheel outward or push it inward as desired. To lock the steering column in position, push the control upward until fully engaged.

WARNING!

Do not adjust the steering column while driving. Adjusting the steering column while driving or driving with the steering column unlocked, could cause the driver to lose control of the vehicle. Failure to follow this warning may result in serious injury or death.

STEERING WHEEL

Power Tilt/Telescoping Steering Column — If Equipped

This feature allows you to tilt the steering column upward or downward. It also allows you to lengthen or shorten the steering column. The power tilt/telescoping steering column control is located below the multifunction lever on the steering column...

Other information:

Dodge Charger 2011-2025 Owner's Manual: To Lock The Vehicle’s Doors And Trunk

With one of the vehicle’s Passive Entry key fobs within 5 ft (1.5 m) of either front door handle, pushing the Passive Entry lock button will lock the vehicle. NOTE: DO NOT grab the door handle, when pushing the door handle lock button. This could unlock the door(s)...

Dodge Charger 2011-2025 Owner's Manual: Programming HomeLink® To A Miscellaneous Device, Reprogramming A Single HomeLink® Button

Programming HomeLink® To A Miscellaneous Device Follow the procedure on programming HomeLink® to a garage door opener. Be sure to determine if the device has a rolling code, or non-rolling code before beginning the programming process. NOTE: Canadian radio frequency laws require trans- mitter signals to time-out (or quit) after several seconds of transmission, which may not be long enough for HomeLink® to pick up the signal during programming...