Dodge Charger: ENGINE COMPARTMENT / Adding Washer Fluid
The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level at regular intervals. Fill the reservoir with windshield washer solvent (not radiator antifreeze) and operate the system for a few seconds to flush out the residual water.
When refilling the washer fluid reservoir, apply some washer fluid to a cloth or towel and wipe the wiper blades clean. This will help blade performance.
To prevent freeze-up of your windshield washer system in cold weather, select a solution or mixture that meets or exceeds the temperature range of your climate. This rating information can be found on most washer fluid containers.
The fluid reservoir will hold nearly 1 Gallon (4 Liters) of washer fluid when the message “Low Washer Fluid” appears in the instrument cluster.
WARNING!
Commercially available windshield washer solvents are flammable. They could ignite and burn you. Care must be exercised when filling or working around the washer solution.
Checking Oil Level
WARNING!
Never smoke while working in the engine compartment: gas and inflammable
vapors may be present, with the risk of fire.
Be very careful when working in the engine compartment when the engine
is hot: you may get burned...
Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery. Water will never have
to be added, and periodic maintenance is not required.
NOTE:
The battery is stored under an access cover in the trunk...
Other information:
Dodge Charger 2011-2025 Owner's Manual: Sealing A Tire With Tire Service Kit
(A) Whenever You Stop To Use Tire Service Kit: Pull over to a safe location and turn on the vehicle’s Hazard Warning flashers. Verify that the valve stem (on the wheel with the deflated tire) is in a position that is near to the ground. This will allow the Tire Service Kit Hoses (4) and (8) to reach the valve stem and keep the Tire Service Kit flat on the ground...
Dodge Charger 2011-2025 Owner's Manual: Non-Rolling Code Garage Door Opener Final Steps
Push and hold the programmed HomeLink® button and observe the HomeLink® indicator light. If the HomeLink® indicator light stays on constantly, programming is complete. Push the programmed HomeLink® button to confirm that the garage door opener motor operates...
Categories
- Manuals Home
- Dodge Charger Owners Manual
- Dodge Charger Service Manual
- Jump Starting Procedure
- Launch Control
- SCHEDULED SERVICING
- New on site
- Most important about car
Illuminated Vanity Mirrors
To access an illuminated vanity mirror, flip down one of the visors and lift the cover.
Sun Visor “Slide-On-Rod” Feature — If Equipped
The sun visor “Slide-On-Rod” feature allows for additional flexibility in positioning the sun visor to block out the sun.
Fold down the sun visor. Unclip the visor from the corner clip. Pivot the sun visor toward the side window. Extend the sun visor for additional sun blockage.