Other information:
Programming HomeLink® To A Miscellaneous Device
Follow the procedure on programming HomeLink® to a garage door opener. Be sure
to determine if the device has a rolling code, or non-rolling code before beginning
the programming process.
NOTE:
Canadian radio frequency laws require trans- mitter signals to time-out (or quit)
after several seconds of transmission, which may not be long enough for HomeLink®
to pick up the signal during programming...
The BSM system uses two radar sensors, located inside the rear fascia/bumper,
to detect highway licensable vehicles (automobiles, trucks, motorcycles, etc.) that
enter the blind spot zones from the rear/front/side of the vehicle.
When the vehicle is started, the BSM Warning Light will momentarily illuminate
in both outside rearview mirrors to let the driver know that the system is operational...