Dodge Charger: EXTERIOR LIGHTS / Daytime Running Lights (DRLs) — If Equipped

Dodge Charger 2011-2024 Owner's Manual / GETTING TO KNOW YOUR VEHICLE / EXTERIOR LIGHTS / Daytime Running Lights (DRLs) — If Equipped

The Daytime Running Lights will turn on when the engine is started and will remain on unless the headlights are turned to the on position, the parking brake is applied, or the ignition is placed in the OFF position.

NOTE:

For vehicles sold in Canada, the Daytime Running Lights will automatically deactivate when the front fog lights are turned on.
If allowed by law in the country in which the vehicle was purchased, the Daytime Running Lights can be turned on and off using the Uconnect system.
On some vehicles, the Daytime Running Lights may deactivate, or reduce intensity, on one side of the vehicle (when a turn signal is activated on that side), or on both sides of the vehicle (when the hazard warning lights are activated).

Multifunction Lever

T..

High/Low Beam Switch, Automatic High Beam — If Equipped

High/Low Beam Switch Push the multifunction lever toward the instrument panel to switch the headlights to high beams. Pulling the multifunction lever back will turn the low beams on...

Other information:

Dodge Charger 2011-2024 Owner's Manual: Automatic Transmission

The gear selector must be in the PARK position before you can start the engine. Apply the brakes before shifting into any driving gear. CAUTION! Shift into or out of PARK or REVERSE only after the vehicle has come to a complete stop. Do not shift between PARK, REVERSE, NEUTRAL, or DRIVE when the engine is above idle speed...

Dodge Charger 2011-2024 Owner's Manual: Launch Control

WARNING! Launch Mode is intended for off-highway or off-road use only and should not be used on any public roadways. It is recommended that this feature be used in a controlled environment, and within the limits of the law. The capabilities of the vehicle as measured by the performance pages must never be exploited in a reckless or dangerous manner, which can jeopardize the user’s safety or the safety of others...