Dodge Charger: WARNING LIGHTS AND MESSAGES / Blue Indicator Lights
High Beam Indicator Light
This indicator light will illuminate
to indicate that the high beam headlights are on. With the low beams activated,
push the multifunction lever forward (toward the front of the vehicle) to turn on
the high beams. Pull the multifunction lever rearward (toward the rear of the vehicle)
to turn off the high beams. If the high beams are off, pull the lever toward you
for a temporary high beam on, "flash to pass" scenario.
Adaptive Cruise Control (ACC) Ready Light — If Equipped
This light will turn on when ACC
has been turned on, but is not set.
Cruise Control Ready Indicator
This indicator light will illuminate
when the cruise control is ready, but not set...
Your vehicle is equipped with a sophisticated Onboard Diagnostic system called
OBD II. This system monitors the performance of the emissions, engine, and transmission
control systems...
Other information:
The LaneSense system is operational at speeds above 37 mph (60 km/h) and below
112 mph (180 km/h). The LaneSense system uses a forward looking camera to detect
lane markings and measure vehicle position within the lane boundaries.
When both lane markings are detected and the driver unintentionally drifts out
of the lane (no turn signal applied), the LaneSense system provides a haptic warning
in the form of torque applied to the steering wheel to prompt the driver to remain
within the lane boundaries...
Before starting your vehicle, adjust your seat, adjust the inside and outside
mirrors, fasten your seat belt, and if present, instruct all other occupants to
buckle their seat belts.
WARNING!
When exiting the vehicle, always make sure the ignition is in OFF
mode, remove the key fob from the vehicle and lock the vehicle...