Dodge Charger: INSTRUMENT CLUSTER DISPLAY / Engine Oil Life Reset

Dodge Charger 2011-2024 Owner's Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / INSTRUMENT CLUSTER DISPLAY / Engine Oil Life Reset

Oil Change Required

Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Required” message will display in the instrument cluster display for five seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style.

Unless reset, this message will continue to display each time you place the ignition in the ON/RUN position. To turn off the message temporarily, push and release the OK or arrow buttons. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure.

Vehicles Equipped With Keyless Enter-N-Go — Ignition

Use the steering wheel instrument cluster display controls for the following procedure(s):

Without pressing the brake pedal, push the ENGINE START/STOP button and place the ignition in the ON/RUN position (do not start the engine).
Push and release the down arrow button to scroll downward through the main menu to “Vehicle Info.”
Push and release the right arrow button to access the ”Oil Life” screen.
Push and hold the OK button to reset oil life. If conditions are met, the gauge and numeric display will update to show 100%. If conditions are not met a pop-up message of "To reset oil life engine must be off with ignition in run” will be displayed (for five seconds), and the user will remain at the Oil Life screen.
Push and release the up or down arrow button to exit the submenu screen.

NOTE:

If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.

Secondary Method Of Resetting Engine Oil Life
Without pressing the brake pedal, push the ENGINE START/STOP button and place the ignition to the ON/RUN position (do not start the engine).
Fully press the accelerator pedal, slowly, three times within ten seconds.
Without pushing the brake pedal, push the ENGINE START/STOP button once to return the ignition to the OFF/LOCK position.

NOTE:

If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.

Location And Controls

The instrument cluster display features an interactive display which is located in the instrument cluster. This system conveniently allows the driver to select a variety of useful information by pushing the arrow buttons located on the left side of the steering wheel...

Performance Shift Indicator (PSI) — If Equipped

The PSI is enabled on vehicles with manual transmission, or when a vehicle with automatic transmission is in manual shift mode. The PSI provides the driver with a visual indication within the instrument cluster display when the driver configured gear shift point has been reached and the driver is still accelerating...

Other information:

Dodge Charger 2011-2024 Owner's Manual: ParkSense Warning Display, Enabling And Disabling ParkSense

ParkSense Warning Display The ParkSense Warning screen will only be displayed if Sound and Display is selected from within the Uconnect system. The ParkSense Warning screen is located within the instrument cluster display. It provides visual warnings to indicate the distance between the rear fascia/bumper and the detected obstacle...

Dodge Charger 2011-2024 Owner's Manual: Adding Washer Fluid

The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level at regular intervals. Fill the reservoir with windshield washer solvent (not radiator antifreeze) and operate the system for a few seconds to flush out the residual water...